Thank you for visiting The Mine. Enjoy what’s new with 15% off your first purchase. GO
Enter your email to get your unique code:
Check your inbox (and your spam folder) for your code!
*Excludes select manufacturers. You are consenting to receive marketing emails. You can unsubscribe any time by using the unsubscribe link in our marketing emails, contacting us at The Mine, 11410 NE 122nd Way, Ste. 200, Kirkland WA 98034 or via email at email@example.com.
15% Off Entire Site | End Of Summer Sale! No Minimum Order + Free Shipping* | Use Code RELAX15Details
*This product is a special order item and available to purchase online or by speaking to an associate at this selected store. Choose from store pick-up or home delivery. Standard charges apply for home delivery. (learn more)
Mysteriously illuminating from above, below, or within, StarStrip discreetly goes where no light has gone before. Unthinkably thin strips of LEDs adhere to surfaces unfit for traditional fixtures, bathing the most unusual places for a virtually undetectable, surprisingly unpredictable effect.
For outdoor applications, StarStrand™ Aqua Star, with StarChip™ technology, comes completely surrounded by a pliable plastic coating for use in all weather conditions. Pre-manufactured lengths with water-tight connectors at each end make Aqua Star safe to submerge under water; however, it cannot be submerged in chemically treated water. The minimum single run for this strip is 1’ and the maximum, 20’. The black PC board is backed with heavy duty adhesive 3M tape for easy installation.
Either 30W or 60W Weatherproof Driver required.
12V tapes can be field cut every 2”.
12V Male End Cap and Silcone End Cap (Included) should be used at every termination whether tape is cut or not.
Connector Cords can be used between the driver and the first tape section, between sections, to go around corners and to extend runs.
StarStrand 4-Pin Connector Cords, Input Cords and Output Cords are made from 22 gauge wire. StarStrand 6-Pin Connector Cords, Input Cords and Output Cords are made from 20 gauge wire.
If splicing connector cords is required, splicing needs to be completed before dimming controller or RGB controller. When splicing, the Red/Blue wire are Negative, the Black/Green wire are Positive.
It is not recommended to exceed over 24ft. between the driver and the tape
It is recommended to use the mounting clips or the metal channel in many wet applications because the 3M backing will not be sufficient.