Thank you for visiting The Mine. Enjoy what’s new with 15% off your first purchase. GO
Enter your email to get your unique code:
Check your inbox (and your spam folder) for your code!
*Excludes select manufacturers. You are consenting to receive marketing emails. You can unsubscribe any time by using the unsubscribe link in our marketing emails, contacting us at The Mine, 11410 NE 122nd Way, Ste. 200, Kirkland WA 98034 or via email at firstname.lastname@example.org.
*This product is a special order item and available to purchase online or by speaking to an associate at this selected store. Choose from store pick-up or home delivery. Standard charges apply for home delivery. (learn more)
Mysteriously illuminating from above, below, or within, StarStrip discreetly goes where no light has gone before. Unthinkably thin strips of LEDs adhere to surfaces unfit for traditional fixtures, bathing the most unusual places with dimmable warm white light or a remote-controlled rainbow of vibrant colors for a virtually undetectable, surprisingly unpredictable effect.
StarStrand™ Ultra, with StarChip™ technology, is for applications requiring additional light output. StarStrand Ultra produces over three times the lumens of StarStrand Basic and 50% more than StarStrand Super. This product is also covered with a pliable plastic and features an easy to install 3M tape backed unique white PC board for ultimate light reflection. StarStrand Ultra is available in pre-manufactured lengths with 4 pin connectors installed at each end for fast and sure installation.
Minimum single run is 1 ft.
Maximum single run is 18 ft.
However, if the 150w driver is plugged into the 12V 4-Way Connector, you may add another 14 ft. on the opposite side of the original leg making the maximum run 32 ft.
12V tapes can be field cut every 2”. Once the tape is cut you cannot add a power connector or rejoin to start section.
Can be connected by wall plug or direct wire.
Polarity must be maintained. Each tape has positive pin. Connectors are marked with + symbol. Positive polarity must be maintained or a section will not light. It is recommended to install all sections and power up to make sure polarity is correct before adhering to surface.
Use the 12V 4-Way Connector and 2” sections to get 90º angles and turns.
The 12V 4-Way Connector can also be used to power branched runs up to the maximum. Positioning of the 12V driver is critical to limit the amount of drivers required for each installation. Position 12V driver in middle of, or corners of, runs and to power the 12V 4-Way Connector.
Connector Cords can be used between the driver and the first tape section, between sections, to go around corners and to extend runs.
Metal Channel can be used to install on irregular surfaces and also areas where tape will be visible and needs to be concealed.
12V Male End Cap and Silicone End Cap must be used at every termination whether tape is cut or not.
12V Dimming Controller will work on all 12V tapes except Aqua Star. 12V Dimming Controller is installed after the driver and before the first section of tape. There is a 140 watt capacity to this device.
, Eco-Friendly, LED, Energy Saving, Quick Ship, Mfr Specials, Energy Efficient, Title 24
Type of Cabinet Lights:
Under Cabinet Strip & Tape Lights
Bulb is included free Bulbs are not eligible for replacement